Removing And Replacing The Ide Hard-Disk Drive - Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual

Removing and Replacing the IDE Hard-Disk Drive

Fasten the top panel with the screws you set aside earlier.
Step 5
Step 6 Reinstall the chassis on a rack, desktop, or table.
If you are reinstalling IDS-4215 in a rack, see
Reinstall the network interface cables.
Step 7
For the procedure, see

Removing and Replacing the IDE Hard-Disk Drive

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Only use the replacement IDE hard-disk drive from Cisco. We cannot guarantee that other hard-disk
Caution
drives will operate properly with the IPS.
Caution Follow proper safety procedures when removing and replacing the hard-disk drive by reading the safety
warnings in
4200 Series Appliance
This section describes how to remove and replace the IDE hard-disk drive. It contains the following
topics:
•
•
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
3-14
100 Mbps
Installing IDS-4215, page
Regulatory Compliance and Safety Information for the Cisco Intrusion Prevention System
Sensor.
Removing the Hard-Disk Drive, page 3-15
Replacing the Hard-Disk Drive, page 3-16
Top panel screws (4)
Link
FDX 100 Mbps FAILOVER
Link
FDX
10/100 ETHERNE T 0/0
10/100 ETHERNE T 0/0
CONSOLE
Rack Mounting, page
3-7.
Chapter 3 Installing IDS-4215
3-5.
78-16124-01