Removing Nm-Cids; Removing Nm-Cids Offline - Cisco IPS-4240-K9 - Intrusion Protection Sys 4240 Installation Manual

Installation and Removal Instructions
Upgrade NM-CIDS to the most recent Cisco software.
Step 7
For the procedure, see
You are now ready to configure intrusion detection on NM-CIDS.
For More Information
•
•

Removing NM-CIDS

This section describes how to remove NM-CIDS offline or using OIR support, and contains the
following topics:
•
•

Removing NM-CIDS Offline

You must turn off all power to the router before removing NM-CIDS.
To remove NM-CIDS from the router chassis, follow these steps:
Step 1 Prepare NM-CIDS to be powered off:
router# service-module IDS-Sensor slot_number/0 shutdown
Trying 10.10.10.1, 2129 ... Open
Wait for the shutdown message before continuing with Step 2:
%SERVICEMODULE-5-SHUTDOWN2:Service module IDS-Sensor1/0 shutdown complete
Step 2 Turn OFF electrical power to the router.
To channel ESD voltages to ground, do not unplug the power cable.
Step 3 Unplug the command and control network interface cable from NM-CIDS.
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
8-9
Obtaining Cisco IPS Software, page
For the procedure for using HTTPS to log in to IDM, refer to
For the procedures for configuring intrusion prevention on your sensor, refer to the following
documents:
Installing and Using Cisco Intrusion Prevention System Device Manager 5.0
–
Configuring the Cisco Intrusion Prevention System Sensor Using the Command Line Interface
–
5.0
Removing NM-CIDS Offline, page 8-9
Removing NM-CIDS Using OIR Support, page 8-10
Chapter 8
10-1.
Logging In to IDM.
Installing NM-CIDS
78-16124-01