Chapter 4
Installing IDS-4235 and IDS-4250
Replacing the SCSI Hard-Disk Drive
To replace the SCSI hard-disk drive, follow these steps:
Log in to the CLI.
Prepare the appliance to be powered off:
Step 2
sensor# reset powerdown
Wait for the power down message before continuing with Step 3.
Note
Power off the appliance by pressing the power button.
Step 3
Remove the front bezel.
Step 4
For the procedure, see
Step 5
Open the hard-disk drive handle.
Step 6
Insert the hard-disk drive into the drive bay.
Step 7
Close the hard-disk drive handle to lock the drive into place.
Step 8
Power on the appliance by pressing the power button.
Step 9
Replace the front bezel.
For the procedure, see
Note
Four-Post Rack Installation
You can install the appliance in a four-post rack (part number IDS-RAIL-4=).
Caution
Do not install rack kit components designed for another system. Use only the rack kit for the appliance.
Using the rack kit for another system may damage the appliance and cause injury to yourself and others.
This section contains the following topics:
•
•
•
•
•
•
78-16124-01
You can also power down the sensor from IDM.
Installing and Removing the Bezel, page
Installing and Removing the Bezel, page
Replacement drives are shipped without an image. You must reimage the hard-disk drive. For
more information, refer to
Recommended Tools and Supplies, page 4-18
Rack Kit Contents, page 4-18
Upgrading, Downgrading, and Installing System
Installing Cisco Intrusion Prevention System Appliances and Modules 5.0
Installing the Accessories
4-10.
4-10.
Images.
4-17