Layer 2 Protocol Tunneling Commands; Enable L2Protocol_Tunnel; Disable L2Protocol_Tunnel - D-Link DGS-1210/ME series Reference Manual

LAYER 2 PROTOCOL TUNNELING COMMANDS

The Layer 2 Protocol Tunneling (L2PT) commands in the Command Line Interface (CLI) are listed (along with
the appropriate parameters) in the following table.
Command
enable
l2protocol_tunnel
disable
l2protocol_tunnel
config
l2protocol_tunnel ports
show l2protocol_tunnel
Each command is listed in detail, as follows:

enable l2protocol_tunnel

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable the Layer 2 protocol tunneling function:
DGS-1210-28P/ME:5# enable l2protocol_tunnel
Command: enable l2protocol_tunnel
Success.
DGS-1210-28P/ME:5#

disable l2protocol_tunnel

Purpose
Syntax
Description
Parameters
Restrictions
DGS-1210/ME Metro Ethernet Switch CLI Reference Guide
Parameter
[all | <portlist>] type [uni tunneled_protocol [stp | gvrp | protocol_mac [01-00-0C-
CC-CC-CC | 01-00-0C-CC-CC-CD] | all] | nni | none]
To enable the Layer 2 protocol tunneling function.
enable l2protocol_tunnel
The enable l2protocol_tunnel command is used to enable the
Layer 2 protocol tunneling function.
None.
Only Administrator or operator-level users can issue this command.
To disable the Layer 2 protocol tunneling function.
disable l2protocol_tunnel
The disable l2protocol_tunnel command is used to disable the
Layer 2 protocol tunneling function.
None.
Only Administrator or operator-level users can issue this command.
301
40 3