Switch Utility Commands - D-Link DES-3350SR Reference Manual

The switch utility commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
download
upload
ping
traceroute
Each command is listed, in detail, in the following sections.
download
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To download a configuration file:
DES-3350SR Layer 3 Gigabit Switch
Parameters
[ firmware <ipaddr> <path_filename 127> | configuration <ipaddr>
<path_filename 127> {increment}]
[ configuration | log ] <ipaddr> <path_filename 127>
<ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
<ipaddr> {ttl <value 1-60> | port <value 30000-64900> | timeout
<sec 1-65535> | probe <value <1-9>
Used to download and install new firmware or a switch configuration
file from a TFTP server.
[ firmware <ipaddr> <path_filename 127> | configuration
<ipaddr> <path_filename 127> {increment}]
This command is used to download a new firmware or a switch
configuration file from a TFTP server.
firmware Download and install new firmware on the switch from a
TFTP server.
configuration - Download a switch configuration file from a TFTP
server.
<ipaddr> The IP address of the TFTP server.
<path_filename> The DOS path and filename of the firmware or
switch configuration file on a TFTP server. For example,
C:\3226S.had.
increment Allows the download of a partial switch configuration
file. This allows a file to be downloaded that will change only the
switch parameters explicitly stated in the configuration file. All other
switch parameters will remain unchanged.
The TFTP server must be on the same IP subnet as the switch.
Only administrator-level users can issue this command.
54
S U
WITCH TILITY
8
C
OMMANDS