Switch Port Commands - D-Link DES-3326S Command Line Interface Reference Manual

The Switch port commands in the Command Line Interface (CLI) are listed (along with the appropriate
parameters) in the following table.
Command Parameters
config ports [<portlist|all>]
{speed[auto|10_half|10_full|100_half|100_half|1000_full
] learning [enable|disable] state [enable|disable]}
show ports <portlist|all>
Each command is listed, in detail, in the following sections.
D-Link DES-3326S Layer 3 Switch CLI Reference
S P
WITCH
32
5
C
ORT OMMANDS