Jumbo Frame Commands; Enable Jumbo_Frame; Disable Jumbo_Frame; To Enable The Jumbo Frame Function On The Switch - D-Link xStack DGS-3400 Cli Manual

xStack
Certain switches can support jumbo frames (frames larger than 1536 bytes). To transmit frames of up to 9K (and 9220 Bytes
tagged), the user can increase the maximum transmission unit (MTU) size from the default of 1536 by enabling the Jumbo Frame
command.
The jumbo frame commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command

enable jumbo_frame

disable jumbo_frame

show jumbo_frame
Each command is listed, in detail, in the following sections.
enable jumbo_frame
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:

To enable the jumbo frame function on the Switch:

D G S –3 4 26 :5 # e na b le j u m bo _ fr am e
C o m ma n d: e n a bl e j um b o _f r am e
S u c ce s s.
D G S –3 4 26 :5 #
disable jumbo_frame
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To disable the jumbo frame function on the Switch:
®
DGS-3400 Series Layer 2 Gigabit Managed Switch CLI Manual
Parameters
Used to enable the jumbo frame function on the Switch.
enable jumbo_frame
This command is used to allow ethernet frames larger than 1536 bytes to be processed
by the Switch. The maximum size of the jumbo frame may not exceed 9220 Bytes
tagged.
None.
Only Administrator and Operator-level users can issue this command.
Used to disable the jumbo frame function on the Switch.
disable jumbo_frame
This command is used to disable the jumbo frame function on the Switch.
None.
Only Administrator and Operator-level users can issue this command.
J
UMBO
294
F C
RAME OMMANDS
37