Table of Contents
Advertisement
The routing table commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
create iproute default
delete iproute default
show iproute
Each command is listed, in detail, in the following sections.
create iproute default
Purpose
Syntax
Description
Parameters
Restrictions
Example Usage:
To add the default static address 10.48.74.121, with a metric setting of 1, to the routing table:
delete iproute default
Purpose
Syntax
Parameters
<ipaddr> {<metric 1-65535>}
{<network_address>} {static}
Used to create IP route entries to the switch's IP
routing table.
create iproute default <ipaddr> {<metric 1-
65535>}
This command is used to create a default static IP
route entry to the switch's IP routing table.
<ipaddr> − The gateway IP address for the next
hop router.
<metric> − Allows the entry of a routing protocol
metric entry representing the number of routers
between the Switch and the IP address above.The
default setting is 1.
Only administrator-level users can issue this
command.
DES-3550:4#create iproute default 10.48.74.121 1
Command: create iproute default 10.48.74.121 1
Success.
DES-3550:4#
Used to delete a default IP route entry from the switch's IP routing
table.
delete iproute default
R
OUTING
156
25
T
C
ABLE
OMMANDS
Advertisement
Table of Contents
