Basic Switch Commands - D-Link xStack DGS-3600 Series Cli Manual

xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
The basic switch commands in the Command Line Interface (CLI) are listed (with the appropriate parameters) in the following table.
Command
create account
config account
show account
delete account
show session
show switch
show serial_port
config serial_port
enable clipaging
disable clipaging
enable telnet
disable telnet
enable web
disable web
save
reboot
reset
login
logout
show device_status
config command_prompt
config greeting_message
show greeting_message
Each command is listed, in detail, in the following sections.
create account
Purpose
Syntax
Description
Parameters
Parameters
[admin | operator | user] <username 15>
<username>
<username> {<string>}
{baud_rate [9600 | 19200 | 38400 | 115200] auto_logout [never | 2_minutes |
5_minutes | 10_minutes | 15_minutes]}
<tcp_port_number 1-65535>
<tcp_port_number 1-65535>
{[config {<drive_id>} <pathname 64> | log | all]}
{<string>}
{[config |system]} {<string>}
{default}
Used to create user accounts.
create account [admin | operator | user] <username 15>
The create account command is used to create user accounts that consist of a
username of 1 to 15 characters and a password of 0 to 15 characters. Up to eight
user accounts can be created.
admin <username 15> - Enter a name between 1 and 15 alphanumeric characters
to define the administrator account created here.
operator <username 15>- Enter a name between 1 and 15 alphanumeric
characters to define the operator account created here.
user <username 15>- Enter a name between 1 and 15 alphanumeric characters
B
ASIC
9
4
S C
WITCH OMMANDS