Igmp Snooping Commands - D-Link DGS-3212SR Command Line Interface Reference Manual

The switch port commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config igmp_snooping
config igmp_snooping
querier
enable igmp snooping
disable igmp_
snooping
config router_ports
show router_ports
show igmp_snooping
show igmp_snooping
group
show igmp_snooping
forwarding
Each command is listed, in detail, in the following sections.
config igmp_snooping
Purpose
Syntax
Description
Parameters
DGS-3212SR Layer 3 Gigabit Switch
Parameters
[<vlan_name 32> | all] {host_timeout <sec 1-16711450> |
router_timeout <sec 1-16711450> | leave_timer <sec 0-
6711450> state [enable | disable]
[<vlan_name 32> | all] {query_interval <sec 1-65535> |
max_response_time <sec 1-25> | robustness_variable <value 1-
255> | last_member_query_interval <sec 1-25> | state [enable |
disable]
{forward_mcrouter_only}
{<vlan_name 32>} [add | delete] <portlist>
{vlan <vlan_name 32>} {static | dynamic}
{vlan<vlan_name 32>}
{vlan <vlan_name 32>}
{vlan <vlan_name 32>}
NOTE: As a stand-alone switch or as a master switch in a switch stack,
the switch number will be referred to as 15 for all configurations, graphs
and tables.
Used to configure IGMP snooping on the switch.
config igmp_snooping [<vlan_name 32> | all] {host_timeout
<sec 1-16711450> | router_timeout <sec 1-16711450> |
leave_timer <sec 0-16711450> | state [enable | disable]}
This command allows you to configure IGMP snooping on the
switch.
<vlan_name 32> − The name of the VLAN for which IGMP
snooping is to be configured.
all – Selecting this parameter will configure IGMP snooping for all
VLANs on the switch.
IGMP S
NOOPING
135
18
C
OMMANDS