Table of Contents
Advertisement
Installing Drive Wheels
Be sure to check the wheel nut torque again once the windrower has begun operation.
CAUTION
Use a lifting device capable of supporting a minimum of 907 kg (2000 lb.) to lift the wheel assembly.
IMPORTANT:
The windrower must be supported off the ground with stands while the drive wheels are being installed. For instructions,
refer to
Raising Drive Wheel, page
1. Using a forklift, lift the cab end of the windrower
approximately 130 cm (51 in.) (B) off of the ground, or
enough so that left cab-forward drive wheel assembly (A)
can be positioned as shown. Place stand (C) under the
windrower frame.
2. Clean the mounting surface on the wheel drive and the rim.
3. For 540-65R30 tires, install the spacer on the wheel drive.
4. M1170NT5 Windrowers sold in Germany: If replacing a rim
on a windrower equipped with a secondary set of brakes,
remove the spacer plate as follows:
a.
Remove two nuts (A) and bolts (C) attaching spacer
plate (B) to the inside of the wheel rim.
b. Discard nuts (A), spacer plate (B), and bolts (C).
215922
MAINTENANCE AND SERVICING
367.
369
B
Figure 5.223: Windrower Supports in Place
Figure 5.224: Drive Wheel
A
C
C
B
A
A A
Revision A
Advertisement
Table of Contents
Troubleshooting
