Table of Contents
Advertisement
3.4 Installing Drive Wheels
A drive wheel includes a rim and a bar or turf tire, depending on the application. The windrower is shipped with the drive
wheels unattached. They will need to be installed on the windrower.
DANGER
Ensure that all bystanders have cleared the area.
CAUTION
Use a lifting device capable of supporting a minimum of 907 kg (2000 lb.) to lift the wheel assembly.
IMPORTANT:
The windrower must be supported with stands while the drive wheels are being installed.
1. Clear all bystanders from the area.
2. Retrieve the bag of M20 nuts (A) from the cab.
NOTE:
The bag contains 20 or 24 nuts (MD #205397).
3. Use a forklift to lift the cab end of the windrower
approximately 130 cm (51 in.) (B) off of the ground, or
enough so that left cab-forward drive wheel assembly (A)
can be positioned as shown. Place stand (C) under the
windrower frame.
262175
ASSEMBLING WINDROWER
A
Figure 3.14: M20 Wheel Nuts (MD #205397)
Figure 3.15: Windrower Supports in Place
26
A
B
C
Revision A
Advertisement
Table of Contents
