Replacing Beacon Lights; Replacing Cab Dome Bulb - MacDon M2170NT Operator's Manual

Hide thumbs Also See for M2170NT:

Table of Contents

7. Reconnect the wiring harness.

Replacing Beacon Lights

If the beacon lights are damaged or burn out, they will need to be replaced.

1. Disconnect wiring (A) from the harness.

2. Remove nuts (B) and remove beacon (C). Discard the

defective beacon and hardware.

3. Clean any residue from support (D) mounting surface.

4. Install new beacon (C) with gasket (E) onto the support.

Secure it with bolts (F), washers (G), and nuts (B).

5. Torque the nuts to 0.65 Nm (5.75 lbf·in).

If the dome light in the cab ceiling burns out, it will need to be replaced.

To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the

key from the ignition before leaving the operator's seat for any reason.

1. Shut down the engine, and remove the key from the ignition.

2. Insert a slotted screwdriver (or similar prying tool) into

slot (A). Gently pry the lens cover until retaining tabs (B)

are free of the dome light bezel.

3. Remove the lens cover.

MAINTENANCE AND SERVICING

Figure 6.200: Beacon Light Assembly

Figure 6.201: Cabin Dome Light