Replacing Beacon Lights; Replacing Cabin Dome Bulb - MacDon M1170NT5 Operator's Manual

Hide thumbs Also See for M1170NT5:

Table of Contents

7. To install turn/hazard repeater lamp (D) shown in Figure

353, align lamp tab (A) with the slot in the

placard, gently push the lamp into the placard, and rotate it

to secure it.

8. Connect the electrical harness to the receptacle on the rear

of the lamp.

Replacing Beacon Lights

1. Disconnect wiring (A) from the harness.

2. Remove nuts (B) and remove beacon (C). Discard the

defective beacon and hardware.

3. Clean any residue from support (D) mounting surface.

4. Install new beacon (C) with gasket (E) onto the support.

Secure it with bolts (F), washers (G), and nuts (B).

5. Torque the nuts to 0.65 Nm (0.48 lbf·ft).

To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the

key from the ignition before leaving the operator's seat for any reason.

1. Shut down the engine, and remove the key from the ignition.

MAINTENANCE AND SERVICING

Figure 5.197: Signal Repeater

Figure 5.198: Beacon Light Assembly