Checking And Adding Wheel Drive Lubricant Level; Checking Tire Pressures - MacDon M1240 Unloading And Assembly Instructions

2. The engine serial number plate (A) is located on top of
the engine cylinder head cover as shown.

5.1.2 Checking and Adding Wheel Drive Lubricant Level

1. Remove plug (A or B). The lubricant should be visible
through the port or running out slightly.
2. If necessary, add lubricant until lubricant runs out from
the open port (A or B). For lubricant specifications, refer
to 6.1 Lubricants, Fluids, and System Capacities, page
93.
NOTE:
The type of lubricant used after the first lubricant
change is different from the factory supplied lubricant.
3. Reinstall plugs and tighten.

5.1.3 Checking Tire Pressures

Check tire pressures with a gauge.
Drive Wheel Tires:
wheel (A) tire pressures are determined by tire type,
header size, and additional options. Refer to Table
M1240 Tire Inflation Recommendations, page
Caster Wheel Tires: Inflate all caster wheel (B) tires to
110 kPa (16 psi).
214056
PERFORMING PREDELIVERY CHECKS
For optimal performance, drive
71.
Figure 5.2: Engine Serial Number Location
Figure 5.3: Drive Wheel Hub
5.1
Figure 5.4: Windrower Tires
70
Revision A