Adjusting Reel Pressure Alarm - MacDon M2170NT Operator's Manual

4. Use reel speed switches (A) on ground speed lever (GSL) to
set reel speed. The desired speed increases 1 rpm (or
0.1 mph or 0.2 km/h) per momentary press, or continuous
scrolling if switch is pressed and held.

Adjusting Reel Pressure Alarm

The reel pressure alarm alerts the Operator that the reel is operating above the desired pressure. A lower setting will cause
the alarm to be set off more often; a higher setting will allow the alarm to be set off less frequently. This adjustment
requires that the header be engaged.
1. Engage the header to display header run screen 1 or 2.
2. To adjust the reel pressure alarm set point, press REEL
SETTINGS icon (A) to access the REEL ADJUST page.
3. Press set point arrows (A) to set the desired pressure point
that will trigger the alarm.
NOTE:
The factory setting is 200 bar (2900 psi). Adjusting past the
highest setting turns the alarm off.
262171
OPERATION
Figure 5.134: GSL
Figure 5.135: HarvestTouch
Run Screen
Figure 5.136: Reel Adjust Page
258
A
A
™
Display - Header
A
Revision A