Step 16. Install Forming Shield Cover; Step 17. Install Side Deflectors - MacDon A30-S Unloading And Assembly Instructions

STEP 16. INSTALL FORMING
SHIELD COVER
D
a. Loosen carriage bolt (A) securing forming shield
to frame at each side of shield.
b. Remove two 1/2 in. x 1.25 carriage bolts (B)
from each side of forming shield, and retain for
re-installation.
c. Remove eight 3/8 in. x .75 bolts (C) along top of
shield, and two (D) bolts at center that will be
used to secure shield to frame once it is in
place.
B
d. Swing forming shield into position, and support it
so that the 1/2 in. x 1.25 carriage bolts (B) can
be re-installed. Bolt heads to be facing inboard.
Leave bolts loose.
C
169001
UNLOADING AND ASSEMBLY
A
C
B
C
D
e. Install two 3/8 in. x .75 carriage bolts (D) at
center support.
f. Fasten forming shield to frame with 3/8 in. x .75
carriage bolts (C) and serrated nuts at eight
places.
g. Tighten all hardware.
STEP 17. INSTALL SIDE
DEFLECTORS
G
F
RH SHOWN – LH
a. Remove bolt (E), washers, and nut that attaches
adjuster bar (F) to side deflector (G). Note
location of washers relative to adjuster bar.
Retain hardware.
J
b. Remove nuts (H) from support rod.
c. Install each side deflector support rod through
frame at (J), and secure with 3/4 in. hex
nuts (H). Hardware (H) must be tight enough to
hold deflectors in position, but still allow
positioning with adjuster bars.
Swing deflector to inboard position to
assist installation.
d. If forming shield side deflectors are too loose, or
if they bind when moved with adjuster bars, back
off top nut at (H), and adjust lower nut at (H) as
required. Then, holding lower nut with a wrench,
tighten top nut securely against lower nut.
28
H
E
H
NOTE
(continued next page)
Revision E