Checking And Adjusting Forming Shield Deflector Position - MacDon R113 Unloading And Assembly Instructions

10.12 Checking and Adjusting Forming Shield Deflector Position

The position of the side deflectors controls the width and placement of the windrow. Both side deflectors must be evenly
set at the same position. If the side deflectors are not evenly set, follow the steps below to adjust them:
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator's seat for any reason.
1. Loosen locking handle (A).
2. Slide adjuster bar (B) along adjuster plate (C) to the desired
deflector position, and then engage bar (B) into a notch in
the adjuster plate.
3. Tighten locking handle (A).
4. Repeat on the opposite side of the deflector.
262300
PERFORMING PREDELIVERY CHECKS
Figure 10.32: Right Forming Shield Side Deflector
130
A
C
B
Revision A