Chapter 4: Attaching Headers To And Detaching Headers From Windrower; A40Dx Auger Headers; Attaching A40Dx Auger Header - MacDon M2170NT Operator's Manual

Hide thumbs Also See for M2170NT:

Table of Contents

Chapter 4: Attaching Headers to and Detaching Headers from

Refer to this chapter for instructions on attaching MacDon headers to and detaching them from the windrower.

This section details the procedures necessary to physically attach an A40DX Auger Header to the windrower and to

complete its hydraulic and electrical connections.

The windrower's lift linkage and center-link will need to be connected to the header.

To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and

remove the key before leaving the operator's seat, and always engage the safety props before going under the

machine for any reason.

Ensure that all bystanders have cleared the area.

1. Shut down the engine, and remove the key from the ignition.

2. Remove hairpin (A) from pin (B). Remove the pin from

header supports (C). Repeat this step at the opposite side

of the header.

3. Start the engine.

Figure 4.1: Header Support

Troubleshooting