Attaching Headers To M1 Series Windrower; A40 D Auger Header; Attaching An A40 D Auger Header - MacDon M1240 Unloading And Assembly Instructions

4 Attaching Headers to M1 Series Windrower

4.1 A40 D Auger Header

4.1.1 Attaching an A40 D Auger Header

This procedure is for 2017 and newer A40 D headers equipped with the Auger Header Compatibility kit (B5998).
CAUTION
To avoid bodily injury or death from unexpected startup of machine, always stop engine and remove key
from ignition before leaving operator's seat for any reason.
1. Remove hairpin (A) from pin (B) and remove pin from
header supports (C) on both sides of header.
IMPORTANT:
Remove protective cover from exhaust stack prior to
starting engine.
CAUTION
Check to be sure all bystanders have cleared the area.
2. Start engine.
CAUTION
To prevent damage to the header lift linkages when
lowering header lift legs without a header or weight
box attached to the windrower, ensure the float
springs tension is fully released.
NOTE:
If not prompted by the Harvest Performance
Tracker (HPT) display to remove float, remove float
manually by doing the following:
214056
Figure 4.1: Header support
Figure 4.2: Header Float Springs
31
Revision A