Driving Forward - MacDon M105 Operator's Manual

To open right side window, pull over-center latch (A)
forward, and slightly push on window until latch goes
over-center, and lock window in OPEN position.
To close right side window, pull latch (A) inward to until
window closes, and then push rearward to lock.
To fully open window, pull pin (B) out of latch, and push
window open.

Driving Forward

CAUTION
Operate both steering wheel and ground speed lever slowly for familiarization.
tendency of new Operators to oversteer.
1. Place ground speed lever (GSL) (A) in N-DETENT.
Engine can be running.
2. Ensure seat belt is fastened.
3. Start engine if not running.
Engine, page 88.
4. Set GROUND SPEED RANGE switch (B) to either of
the following:
• 2 for road speed: 0–16 mph (25.7 km/h)
• 1 for field speed: 0–11 mph (17.7 km/h)
5. The cab display module (CDM) will display an engine
status at (C).
6. Slowly push throttle
(operating speed).
2270–2330 rpm at (E).
CAUTION
Check again to be sure all bystanders have cleared
the area.
7. Move the GSL (A) out of N-DETENT and slowly forward
to desired speed which will be displayed at (F).
IMPORTANT:
The windrower can be equipped with an automatic steering system for use in the field. An automated steering
system is available as an option and can be installed by a MacDon Dealer. The GSL has been pre-wired at the
factory with a switch. Also refer to
169890
OPERATION
Refer to
Starting the
(D) to full forward
The CDM should display
7.1.3 Automated Steering Systems, page
Figure 4.17: Right Side Window
Figure 4.18: Operator Console
A - Ground Speed Lever
C - Engine Status Display
E - RPM Display
337.
97
Avoid the common
B - Ground Speed Range Switch
D - Throttle
F - Speed Display
Revision A