Table of Contents
Advertisement
Shutting down Engine
Proper shutdown procedures will help reduce potential component wear and damage to the engine.
CAUTION
Park on a flat, level surface with the header on the ground, the ground speed lever (GSL) in the PARK position, and the
steering wheel in the locked position (centered). To confirm that the parking brake is engaged, wait for the
™
HarvestTouch
Display to beep and display a red P symbol
IMPORTANT:
Before stopping the engine, run at low idle for approximately 5 minutes to cool off the hot engine parts and allow the
turbocharger to slow down.
1. Park the windrower on a level surface.
2. Lower the header.
3. Place GSL (B) into PARK.
4. Lock the steering wheel.
5. Turn ignition key (A) counterclockwise to the OFF position.
Engine Temperature
The engine temperature gauge is displayed in the left instrument cluster of the HarvestTouch
Normal engine operating temperature is indicated when the
needle is within the green range of gauge (A).
If the engine temperature exceeds 105°C (221°F), the needle
will move to the red range of the gauge. Depending on the
temperature, the engine will trigger a fault code and an amber
caution or red stop light will illuminate on the display.
When the engine temperature is below 5°C (40°F), the engine
will cycle through a period where it appears to labor until the
engine warms up. Do NOT operate the engine above 1500 rpm
until the engine temperature gauge is above the blue range.
NOTE:
Before taking the ground speed lever (GSL) out of PARK, let the
hydraulic oil warm up to 32°C (90°F). You can view the hydraulic
oil temperature on page four on the HarvestTouch
instructions, refer to
Viewing Engine Cooling Data, page
Engine Oil Pressure
The nominal engine oil pressure is 69 kPa (10 psi) at low idle and 380 kPa (55.1 psi) at maximum rated speed.
262171
OPERATION
B
Figure 5.21: Console
Figure 5.22: HarvestTouch
™
Display. For
202.
199
™
Display.
A
™
Display
Revision A
A
Advertisement
Table of Contents
Troubleshooting
