Detaching A40Dx Auger Header - MacDon M2170NT Operator's Manual

Hide thumbs Also See for M2170NT:

Table of Contents

ATTACHING HEADERS TO AND DETACHING HEADERS FROM WINDROWER

14. Pull platform (A) toward the cab until it stops and the latch

15. If this is the first time the header is connected to the

windrower, calibrate the header. For instructions, refer to

4.4 Calibrating Header on HarvestTouch

4.1.3 Detaching A40DX Auger Header

Detaching the A40DX electrical and hydraulic connections from the windrower is a simple procedure, thanks to the

multicoupler.

To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and

remove the key before leaving the operator's seat, and always engage the safety props before going under the

machine for any reason.

Ensure that all bystanders have cleared the area.

1. Start the engine.

2. If one end of the header does NOT rise fully, rephase the

cylinders as follows:

Press and hold HEADER UP (A) switch until both

cylinders stop moving.

b. Continue to hold the switch for 3–4 seconds. The

cylinders are now phased.

3. Shut down the engine, and remove the key from

the ignition.

Display, page

Figure 4.21: Left Platform

Figure 4.22: Ground Speed Lever (GSL)