MacDon M2170NT Operator's Manual page 170

ATTACHING HEADERS TO AND DETACHING HEADERS FROM WINDROWER
29. Disconnect hose management system (A) from the
windrower by pulling latch lever (B) to open the latch. Keep
the latch open and move hose management system (A)
away from the header with handle (C).
30. Pivot hose management system (B) forward with
handle (A), and engage hook (D) into latch (C) on the
header.
31. Back the windrower away from the header.
32. Shut down the engine, and remove the key from
the ignition.
33. Reinstall clevis pin (B) into header support (C) and secure it
with hairpin (A). Repeat this step on the opposite side.
262171
C
Figure 4.82: Hydraulic Hose Management System
B
C
Figure 4.83: Hydraulic Hose Management System
C
Figure 4.84: Header Stand
150
A
B
A
D
A
B
Revision A