MacDon M2170NT Operator's Manual page 424

Windrower
Hide thumbs Also See for M2170NT:
Table of Contents

Advertisement

4. Remove two bolts (A) holding headlight bracket
assembly (B) in place and slide the bracket forward.
5. Pull the wiring harness connector off the headlight and
remove assembly (B).
6. Remove four machine screws (A) and nylon nuts (B), and
retain the hardware.
7. Remove the old headlight from the bracket, and replace it
with a new headlight.
IMPORTANT:
Do NOT touch the glass of the halogen bulb as oils or other
chemicals from your skin will cause the bulb to fail
prematurely.
8. Attach the headlight to the bracket using four retained
machine screws (A) and nylon nuts (B). Torque the screws
to 2.0–2.7 Nm (18–24 lbf·in).
9. Connect the wiring harness connector to the headlight.
10. Attach headlight bracket assembly (B) using retained
bolts (A).
11. Repeat Step
4, page 404
opposite headlight, if needed.
12. Align the new headlight. For instructions, refer to
Headlights – Engine-Forward, page
262171
MAINTENANCE AND SERVICING
to Step
10, page 404
for the
Aligning
396.
A A
Figure 6.194: Right Headlight Shown – Left Similar
B
Figure 6.195: Right Headlight Shown – Left Similar
A A
Figure 6.196: Right Headlight Shown – Left Similar
404
B
A
B
Revision A

Advertisement

Table of Contents
loading

Table of Contents