D2 Sp Series Draper Headers; Attaching Draper Header Supports - MacDon M2170NT Operator's Manual

Hide thumbs Also See for M2170NT:

Table of Contents

ATTACHING HEADERS TO AND DETACHING HEADERS FROM WINDROWER

4.2 D2 SP Series Draper Headers

To attach the header to the windrower, follow the procedures provided here in the order presented.

The draper header supports are required to attach the header to a windrower.

For headers that were previously attached to a combine, order draper header supports bundle B7266.

To prevent bodily injury or death from the unexpected start-up of the machine, always stop the engine and remove the

key from the ignition before making adjustments to the machine.

Ensure that the correct header supports are used:

• D2 SP Draper Headers must use header supports (A).

• A feature that distinguishes support (A) from all other types

is that rubber block (B) is attached to the support using

• To order header supports, refer to the header parts catalog.

1. Shut down the engine, and remove the key from

the ignition.

2. Remove hairpin (A) from clevis pin (B) on draper header

support (C). Remove clevis pin (B).

Figure 4.39: Draper Header Supports

Figure 4.40: Draper Header Support