Table of Contents
Advertisement
3. Place ground speed lever (GSL) (A) in PARK.
4. Shut down the engine, and remove the key from
the ignition.
5. Place wheel chocks (B) under the front and back of each
caster wheel (A).
NOTE:
Ensure that the caster wheels are pointed forward or
backward, before placing the wheel chocks, as shown in the
illustration at right.
6. Place a jack with a lifting capacity of at least 2268 kg
(5000 lb.) under wheel leg jack point (A).
NOTE:
The jack saddle must fit within the 50 mm (2 in.) retaining
ring (C) at the jack point.
7. Raise the jack until the drive wheel is slightly off the
ground.
8. Place a jack stand beneath lift cylinder mount (B).
IMPORTANT:
Do NOT place the jack stand under the cylinder. Use a small
metal plate on top of the jack stand.
9. Lower the windrower onto the jack stand.
262171
MAINTENANCE AND SERVICING
Figure 6.222: Ground Speed Lever
Figure 6.223: Chocking Caster Wheels
Figure 6.224: Drive Wheel Jack Point
421
A
A
C
A
B
B
Revision A
Advertisement
Table of Contents
Troubleshooting
