Attaching D1X And D1Xl Series Draper Headers - MacDon M2170NT Operator's Manual

Hide thumbs Also See for M2170NT:

Table of Contents

ATTACHING HEADERS TO AND DETACHING HEADERS FROM WINDROWER

1. Shut down the engine, and remove the key from

the ignition.

2. Remove the hairpin from clevis pin (B) on draper header

support (A). Remove clevis pin (B).

3. Position draper header support (B) on windrower lift

linkage (A). Reinstall clevis pin (C).

To ensure that the pin doesn't snag the windrow, install the

clevis pin on the outboard side of the draper header

4. Secure clevis pin (C) with hairpin (D).

5. Repeat Step

remaining draper header support.

4.3.2 Attaching D1X and D1XL Series Draper Headers

The windrower's lift linkage and center-link will need to be connected to the draper header.

To prevent bodily injury or death from the unexpected start-up or fall of a raised machine, always stop the engine and

remove the key before leaving the operator's seat, and always engage the safety props before going under the

machine for any reason.

Ensure that all bystanders have cleared the area.

1. Shut down the engine, and remove the key from the ignition.

to install the

Figure 4.86: Draper Header Support

Figure 4.87: Draper Header Support