Chapter 8: Attaching Headers To M Series Windrower; Attaching Header Boots - MacDon M155E4 Assembly Instruction Manual

Chapter 8: Attaching Headers to M Series Windrower

Follow these procedures to safely attach these MacDon headers to the windrower.

8.1 Attaching Header Boots

Header boots are required to attach a D Series or D1 Series Draper Header to the windrower. Attach header boots to the
windrower's lift linkage if they are not already installed. Header boots are supplied with the header.
IMPORTANT:
To prevent damage to the lift system when lowering the header
lift linkages without a header or a weight box attached to the
windrower, ensure that the float engagement pin is installed in
storage position (B) and NOT in engaged position (A).
1. Remove pin (B) from boot (A).
215794
Figure 8.1: Header Float Linkage
Figure 8.2: Header Boot
147
A
A
B
B
Revision A