MacDon M2170NT Operator's Manual page 369

Hide thumbs Also See for M2170NT:

Table of Contents

Park on a flat, level surface with the header on the ground, the ground speed lever (GSL) in the PARK position, and the

steering wheel in the locked position (centered). To confirm that the parking brake is engaged, wait for the

HarvestTouch

Display to beep and display a red P symbol

It is best to change lubricant in the morning before it warms up. If the engine is hot, wait 10 minutes before checking the

lubricant level to allow the lubricant to cool and settle in the sump.

1. Park the windrower on a level surface.

2. Shut down the engine, and remove the key from the ignition.

3. Place a 4 liter (1 U.S. gallon) drain pan under the gearbox.

4. Remove drain plug (A) and allow the lubricant to

finish draining.

5. Inspect the drain plug. Small metal shavings are normal. If

there are any larger metal pieces, Contact your MacDon

6. Reinstall drain plug (A), and remove check plug (B).

7. Add lubricant until the oil level reaches check plug (B). For

lubricant specifications, refer to

and System Capacities, page

8. Reinstall check plug (B).

9. Operate the engine at low idle, and check for leaks at the

check plug and drain plug.

MAINTENANCE AND SERVICING

6.1.2 Lubricants, Fluids,

Figure 6.101: M2170NT Engine Gearbox

Troubleshooting