MacDon M2170NT Operator's Manual page 375

7. Swipe down to OPERATOR PRESENT (A) and confirm the
following conditions:
• The status must be ON when the Operator is sitting on
the seat.
• The status must be OFF when the Operator is not sitting
on the seat.
NOTE:
If the two conditions listed above are NOT true, the
Operator Presence System requires adjustment. Contact
your MacDon Dealer.
Perform the following checks on the Operator Presence System every 5 years.
Checking the Operator Presence System and engine lock-out systems:
CAUTION
Park on a level surface with the ground speed lever (GSL) in the PARK position and the steering wheel in the locked
(centered) position. Wait for the HarvestTouch
brake is engaged.
DANGER
Ensure that all bystanders have cleared the area.
1. With the windrower engine running, place the ground speed lever (GSL) in PARK and center the steering wheel until
it locks.
2. With everyone clear of the machine, engage the HEADER ENGAGE switch:
a. After the header drives are running, stand up out of the seat. In approximately 5 seconds, the header should
shut off.
b. If NOT, the Operator Presence System requires adjustment. Contact your MacDon Dealer.
NOTE:
To restart the header, move the HEADER ENGAGE switch to the OFF position and then back to the ON position.
3. With the windrower moving at less than 8 km/h (5 mph):
a. Stand up out of the seat.
b. The HarvestTouch
accompanied by a steady tone. At 0, the engine shuts down.
c. If the engine does NOT shut down, the Operator Presence System requires adjustment. Contact your
MacDon Dealer.
4. With the windrower moving at more than 8 km/h (5 mph):
a. Stand up out of the seat.
b. After a 2 second delay, the HarvestTouch
c. If NOT, the Operator Presence System requires adjustment. Contact your MacDon Dealer.
262171
MAINTENANCE AND SERVICING
™
Display to beep and display a red P symbol to confirm that the parking
™
Display will flash NO OPERATOR DETECTED, ENGINE SHUT DOWN IN 5...4...3...2...1...
™
Display will show NO OPERATOR DETECTED along with a tone.
Figure 6.111: Operator Present Status (Set to ON)
355
A
Revision A