Detaching Windrower From Tractor - MacDon 5000 Operator's Manual

OPERATION
ATTACHING WINDROWER TO TRACTOR
(conl'd)
5. Connect remote hydraulic hoses as follows:
a. Connect the two tongue swing hoses (H) so
that when the tractor control is moved
forward, the swing cylinder wil;1 extend ,
moving the wind·rower to the right. When the
tractor control handle is moved back, the
swing cylinder will retract, moving the
windrower to the left.
b. Connect the two lift cylinder hoses (J ) so that
when the tractor control is moved back, the
lift
cylinder will extend,
raising the header.
When the tractor control is moved forward ,
the lift cylinder will retract, lowering the
header.
6. Connect the windrower wiring harness plug
(K) to outlet on tractor.
DETACHING WINDROWER FROM TRACTOR
A
CAUTION: To prevent clccidental
movement of tractor, shut off
engine, engage parking blrake, and
remove key.
To maintain stability, always hlwer the
machine completely. Block windrowerwheels
before detaching from tractor.
Park machine on flat level surface.
Move remote cylinder control valve lIever back
and forth to relieve stored hydraulic pressure.
1. Pull pin securing jack and move to working
position (A) at front of tongue.
2. Lower jack to take weight off tractm drawbar.
3. Unlock torque arm chain from keyhole slot in
torque arm mounting plate. Remove hydraulic
pump assembly and store at (8).
4. Disconnect hydraulic hoses andi electrical
hamess. Store with ends off ground.
5. Remove hitch pin lock (C) and unhook chain
(D) from tractor. Wrap chain around
windrower tongue for stora!:le. Raise
windrower tongue with jack to cle;::lr hitch pin.
6. Slowly drive tractor away from wind rower.
17
AND ELECTRICAL
MOVE JACK TO WORKING POSITION