2. When cutting on the ground, lower the header until the
cutterbar is on the ground.
NOTE:
To minimize scooping rocks when operating at the flattest
header angle, lower the header skid shoes. For instructions,
refer to the header operator's manual.
3. When cutting off the ground, set the cutting height with
the header height controls on the GSL. For instructions,
refer to
5.4.5 Setting Header Height, page
4. Press FLOAT SETTINGS icon (A) on the HarvestTouch
Display to show the float setting page.
262171
OPERATION
Figure 5.94: Header Float – Cutterbar on Ground
247.
Figure 5.95: Header Float – Cutterbar off Ground
™
Figure 5.96: HarvestTouch
239
A
™
Display
Revision A