Table of Contents
Advertisement
13. Start the engine and set throttle (A) to achieve an engine
speed of 1500 rpm.
14. Move the GSL out of PARK notch (B) and into the neutral
position.
15. Move the GSL forward in the slot until it is approximately
25 mm (1 in.) from neutral and then observe the drive
wheels for movement:
• If the drive tires do not move, the parking brakes are
working properly.
• If the drive tires move, the parking brakes require
replacement. Contact your MacDon Dealer.
16. Move the GSL back to park, and shut down machine.
17. Reconnect wheel motor power connectors (C) on the left
and right wheel motors:
• Connector P274 is on the left wheel motor
• Connector P264 is on the right wheel motor
18. Reinstall access panels (B) onto left and right drive wheel
legs and secure with bolt (A).
262171
MAINTENANCE AND SERVICING
Figure 6.170: Operator's Console
Figure 6.171: Wheel Legs
390
A
C
B
B
A
Revision A
Advertisement
Table of Contents
Troubleshooting
