Table of Contents
Advertisement
ATTACHING HEADERS TO AND DETACHING HEADERS FROM WINDROWER
11. Lower the header fully using HEADER DOWN switch (A).
12. Press HEADER TILT switches (B), as needed, on the GSL to
release the load on center-link.
13. Windrowers with self-aligning center-link:
a.
Press REEL UP switch (A) to disengage the center-link
from the header.
b. Shut down the engine, and remove the key from the
ignition.
14. Windrowers without self-aligning center-link:
a.
Shut down the engine, and remove the key from the
ignition.
b. Disconnect the center-link by lifting release (A) and lift
hook (B) off the header.
262171
A
Figure 4.119: GSL
Figure 4.120: GSL
Figure 4.121: Hydraulic Center-Link
167
B
A
A
B
Revision A
Advertisement
Table of Contents
Troubleshooting
