Table of Contents
Advertisement
6. Using a forklift, lift the cab end of the windrower
approximately 130 cm (51 in.) (B) off of the ground, so that
wheel assemblies (A) can be removed from or installed
onto the wheel drive hubs.
7. Place stands or cribbing (C) under the windrower frame.
Removing Drive Wheels
The drive wheels may need to be removed for service, storage, or replacement.
CAUTION
Use a suitable lifting device capable of supporting a minimum of 907 kg (2000 lb.) to lift the wheel assembly away from
the windrower.
1. Raise windrower drive wheel (A) off the ground. For
Raising Drive Wheel – Jack Method,
instructions, refer to
Raising Drive Wheels – Forklift Method, page
page 420
or
422.
2. Remove wheel nuts (B).
262171
MAINTENANCE AND SERVICING
Figure 6.227: Forklift Raising Windrower
Figure 6.228: Drive Wheel Assembly
423
B
A
A
C
B
Revision A
Advertisement
Table of Contents
Troubleshooting
