MacDon M2170NT Operator's Manual page 426

Figure 6.198: LED Light Locations – Deluxe Cab Only
1. Shut down the engine, and remove the key from the ignition.
2. Disconnect wiring harness (A).
NOTE:
If you do NOT have to also replace hinge bracket (C), then
follow Step 3, page 406
also replace hinge bracket (C), then remove mounting
nut (E) inside the cab roof. This task requires two people:
• All cab-forward work lights: Remove the cab-forward
sun shade. Open the access panel in the headliner to
access the work light mounting nuts. Tighten the
mounting nuts to 27 Nm (239 lbf·in).
• Two rear right work lights: One work light is mounted
externally and is readily accessible. To remove the
mounting hardware for the other work light, remove
the radio panel from the cab. Tighten the mounting
nuts to 15 Nm (133 lbf·in).
• Two rear left work lights: Contact your MacDon dealer
to have the headliner removed.
3. Remove bolt and nut (B) from hinge bracket (C).
4. Remove LED lamp assembly (D).
5. Mount new LED assembly (with its hinge bracket removed)
to existing hinge bracket (C) using bolt and nut (B).
6. Tighten the hinge nut to 7.5 Nm (66 lbf·in).
262171
MAINTENANCE AND SERVICING
C
B
to Step 7, page 407. If you have to
A
A
Figure 6.199: Front LED Work Light
406
C
B A
D
E
Revision A