Table of Contents
Advertisement
ATTACHING HEADERS TO AND DETACHING HEADERS FROM WINDROWER
2. Before beginning this procedure, make sure both draper
header supports (A) are either:
• (B) Installed on the windrower lift linkages, or
• (C) Installed in the header legs
For instructions on installing the header supports onto the
windrower, refer to
4.2.1 Attaching Draper Header
Supports, page
129. Header supports are typically left
installed in the header legs when the header is detached
from the windrower.
3. Extend the windrower wheels from narrow transport into
field mode. For instructions, refer to
Field Mode, page
224.
4. Rotate left signal light placard (A) to the up (vertical)
position before connecting the windrower to a header.
262171
Extending Wheels –
131
A
B
C
A
Figure 4.42: Header Supports Installed
Figure 4.43: Left Signal Light Placard
A
Revision A
Advertisement
Table of Contents
Troubleshooting
