MacDon M2170NT Operator's Manual page 362

5. Make sure arrow (A) lines up with the UNLOCK symbol on
the end cap.
6. Pull off the end cap.
7. Check aspirator duct opening (A) for obstructions or
damage. Clean it if necessary.
8. Place the cover on the platform.
NOTE:
Hoses can be left connected to the cover.
9. Pull out primary filter element (A).
IMPORTANT:
Be extremely careful with the dirty element until it is
completely out of the housing. Accidentally bumping it
while still inside may cause dirt and dust to contaminate
the clean side of the filter housing.
10. If necessary, also change secondary filter (B). For
instructions, refer to Replacing Secondary Air Filter, page
345.
262171
MAINTENANCE AND SERVICING
Figure 6.90: Air Filter
Figure 6.91: Air Filter
Figure 6.92: Air Filter
342
A
A
A
B
Revision A