ATTACHING HEADERS TO AND DETACHING HEADERS FROM WINDROWER
7. Clean the multicouplers and receptacles to prevent
contamination of the hydraulic system.
8. Push button (A) on the rear multicoupler receptacle and
rotate handle (B) away from the windrower.
9. Open cover (C). Position multicoupler (D) onto the
receptacle. Align the pins in the coupler with the slots in
handle (B) and rotate the handle toward the windrower so
that the coupler is locked onto the receptacle and
button (A) pops out.
10. Push button (E) on the front multicoupler receptacle and
rotate handle (F) away from the windrower.
11. Open cover (G) and position multicoupler (H) onto the
receptacle. Align the pins in the coupler with the slots in
the handle, and rotate the handle toward the windrower so
that the coupler is locked onto the receptacle and
button (E) snaps out.
12. Remove the cover from receptacle (A). Connect the
header's electrical harness to the receptacle.
13. Push latch (A) to unlock platform (B).
262171
F
H
G
Figure 4.18: Knife/Reel/Auger Drive Multicoupler
A
Figure 4.19: Electrical Connectors
B
Figure 4.20: Left Platform
120
B
E
D
A
C
A
1015478
Revision A