MacDon M2170NT Operator's Manual page 162

ATTACHING HEADERS TO AND DETACHING HEADERS FROM WINDROWER
9. Retrieve draper drive and reel control multicoupler (A) from
the hydraulic hose management system.
10. Push knob (B) on the hydraulic receptacle and pull
handle (C) fully away from the windrower.
11. Open cover (D) and position the coupler onto the
receptacle.
12. Align the pins in the coupler with the slots in handle (C) and
push the handle toward the windrower so that the coupler
locks onto the receptacle and knob (B) pops out.
13. Remove the cover from electrical connector (E).
14. Push the electrical connector onto the receptacle. Secure
the connector by turning the collar on the electrical
connector clockwise.
15. Retrieve knife and reel drive multicoupler (A) from the
hydraulic hose management system.
16. Push knob (B) on the hydraulic receptacle and pull
handle (C) fully away from the windrower.
17. Open cover (D) and position the coupler onto the
receptacle.
18. Align the pins in the coupler with the slots in handle (C),
and push the handle toward the windrower so that the
coupler locks onto the receptacle and knob (B) snaps out.
19. Ensure that the hydraulic hose routing is as straight as
possible.
IMPORTANT:
Straight routing will prevent abrasion damage to the
hydraulic hoses.
262171
E
Figure 4.62: Draper/Reel Multicoupler
Figure 4.63: Knife/Reel Drive Multicoupler
Figure 4.64: Hydraulic Multicouplers and Hose
Routing
142
A
B
D
A
D
B
C
F
C
Revision A