Table of Contents
Advertisement
8. Press switch (A) to activate the road lights.
NOTE:
Always use these lights when driving windrower on roads.
9. Press switch (B) for high/low beams when other vehicles
are approaching.
IMPORTANT:
Do NOT use the field lights on the road; other drivers may
be confused by them.
10. Press switch (C) to activate the beacons.
11. Press switch (D) to activate the hazard lights.
12. Set the desired maximum ground speed limit. For
instructions, refer to
Adjusting Ground Speed Limit, page
203.
NOTE:
Maximum ground speed can be set while the windrower is
moving. Anticipate the acceleration or deceleration if
changing the maximum speed.
13. Slowly push throttle (A) to full forward (operating speed).
14. Move ground speed lever (GSL) (B) out of PARK and slowly
forward to the desired speed.
15. If towing a header, refer to
page
218.
262171
OPERATION
Towing Header with Windrower,
C
B
Figure 5.42: Light Switches
B
A
Figure 5.43: Console
Figure 5.44: Towing a Header
211
D
A
Revision A
Advertisement
Table of Contents
Troubleshooting
