Checking And Replacing Fuses; Replacing Circuit Breakers And Relays - MacDon M2170NT Operator's Manual

Hide thumbs Also See for M2170NT:

Table of Contents

Checking and Replacing Fuses

If you suspect that a fuse needs replacement, you will need to open the fuse box and examine the fuse in question. The

decal inside the fuse box aids the Operator in identifying the function of a given fuse.

1. To check a fuse, pull fuse (A) out of the receptacle and

visually examine it.

2. To replace a fuse, insert a new fuse into the receptacle.

Replacement fuses should match the rating on the decal

inside the fuse panel cover. For information, refer to

Panel and Relay Module Decals, page

If a circuit breaker or relay in the windrower's main fuse box is nonfunctional, it must be replaced.

To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the

key from the ignition before leaving the operator's seat for any reason.

1. Shut down the engine, and remove the key from the ignition.

2. Open the fuse box cover. For instructions, refer to

MAINTENANCE AND SERVICING

Figure 6.211: Fuses

6.15.7 Accessing Circuit Breakers and Fuses, page