Table of Contents
Advertisement
2. Tighten wheel nuts (A) to 163 Nm (120 lbf·ft) using the
tightening sequence shown at right. Repeat the tightening
sequence three times.
3. Position wheel assembly (D) in forked caster (C).
4. Install eight bolts (A) and nuts (four on each side of the
caster) to secure axle (B) to caster (C). Torque the nuts to
102 Nm (77 lbf·ft).
5. Lower the caster wheel. For instructions, refer to
Caster Wheel, page
430.
Removing Forked Caster Wheel
Once the caster wheel has been raised, the forked caster axle assembly can be removed from the windrower, and the
wheel can be removed from the axle assembly.
CAUTION
The wheel assembly is heavy. Support the wheel assembly before removing the axle bolts.
262171
MAINTENANCE AND SERVICING
Figure 6.237: Caster Wheel Tightening Sequence
Lowering
Figure 6.238: Caster Wheel Assembly
428
A
1
6
3
8
5
C
A
4
7
2
D
B
Revision A
Advertisement
Table of Contents
Troubleshooting
