Attaching And Detaching Headers; Attaching A D-Series Header; Attaching A D-Series Header: Hydraulic Center-Link - MacDon M105 Operator's Manual

4.5 Attaching and Detaching Headers

4.5.1 Attaching a D-Series Header

Refer to the procedure that is appropriate for the center-link installed on the windrower:
•
Attaching a D-Series Header: Hydraulic Center-Link, page 131
•
Attaching a D-Series Header: Mechanical Center-Link, page 136

Attaching a D-Series Header: Hydraulic Center-Link

NOTE:
This topic assumes that draper header boots have already been attached to the windrower lift linkage. If that is
not the case, refer to
4.6.2 Attaching Header Boots, page
To attach a D-Series header to a windrower equipped with a hydraulic center-link, follow these steps:
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
1. Remove the hairpin (A) from pin (B) and remove the
pins from both header legs.
CAUTION
Check to be sure all bystanders have cleared the area.
2. Start engine and activate HEADER DOWN button (A)
on the ground speed lever (GSL) to fully retract header
lift cylinders.
169890
OPERATION
168.
Figure 4.78: Header Leg
Figure 4.79: GSL
131
Revision A