MacDon M2170NT Operator's Manual page 408

Hide thumbs Also See for M2170NT:

Table of Contents

1. Park the windrower on a level surface.

2. Configure the windrower for cab forward operation. For instructions, refer to

3. Set the ground speed limit to the lowest setting for cab forward operation. For instructions refer to

Speed Limit, page

4. Raise the drive tires off the ground. For instructions, refer to one of the following methods depending on the

equipment available:

Raising Drive Wheel – Jack Method, page 420

Raising Drive Wheels – Forklift Method, page 422

Ensure that all bystanders have cleared the area.

5. Start the engine. For instruction refer to

6. Set throttle (A) to low idle, and move the ground speed

lever (GSL) out of PARK notch (B) and into the neutral

7. Watch the drive wheels: if the neutral setting is correct, the

wheels will not move. If the wheels move, contact your

MacDon Dealer.

8. When the neutral setting check is complete, turn the

machine off.

9. Open the hood. For instructions, refer to

MAINTENANCE AND SERVICING

Starting Engine,

6.3.1 Opening

Figure 6.167: Operator's Console

Driving Forward in Cab-Forward Mode,

Adjusting Ground

Troubleshooting