Extending Wheels - Field Mode - MacDon M2170NT Operator's Manual

2. Remove two bolts (A) at the center of the drive wheel.
3. Remove cap (B) and flip it over so that the convex side
faces in.
NOTE:
The cap depresses a pin which disengages the wheel drive.
4. Reinstall bolts (A) to secure cap (B).
5. Repeat Step 2, page 224
drive wheel.
6. To engage the wheel drives, reverse cap (B). Ensure that
the pin at the center of the wheel pops out to engage the
wheel drive.
NOTE:
Engaging the wheel drives may require rocking the wheels
slightly.
Extending Wheels – Field Mode
The narrow transport feature allows the drive wheel legs and walking beam extensions to extend from narrow transport to
field position.
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator's seat for any reason.
NOTE:
This procedure can be done with the seat in cab- or engine-forward position.
1. Ensure the narrow transport function is enabled on the HarvestTouch
Enabling Narrow Transport System in the HarvestTouch
2. Disconnect the header or weight box from the windrower. Refer to
from Windrower, page
3. Shut down the engine, and remove the key from the ignition.
262171
to Step 4, page 224 on the other
111.
OPERATION
Figure 5.67: Wheel Drives – 10 Bolt
™
Display. For instructions, refer to
™
Display, page 99.
4 Attaching Headers to and Detaching Headers
224
B
A
3.17.10
Revision A