MacDon M2170NT Operator's Manual page 245

4. Retrieve the transport harness from holder (A), located
behind the left platform, and connect it to electrical
receptacle (B).
5. Rotate left signal light placard (A) to the up (vertical)
position before connecting to a header.
6. At the front of the windrower, rotate walking beam lockout
valve handle (A) to the open position (in line with
the valve).
7. Remove lockout pins (B) from the sliding drive wheel legs
and place them on top of the frame.
WARNING
Ensure that all bystanders have cleared the area.
8. Start the engine.
9. Run the engine at low idle.
262171
OPERATION
B
A
Figure 5.68: Transport Electrical Connector
Figure 5.69: Left Signal Light Placard
Figure 5.70: Transport Locks
225
A
A
B
Revision A