Table of Contents
Advertisement
4.5 Attaching and Detaching Headers
Follow these procedures to safely attach and detach these MacDon headers to and from the windrower.
4.5.1 Attaching Header Boots
Header boots are required to attach a D Series or D1 Series Draper Header to the windrower. Attach header boots to the
windrower's lift linkage if they are not already installed. Header boots are supplied with the header.
IMPORTANT:
To prevent damage to the lift system when lowering the header
lift linkages without a header or a weight box attached to the
windrower, ensure that the float engagement pin is installed in
storage position (B) and NOT in engaged position (A).
1. Remove pin (B) from boot (A).
2. Position boot (B) onto lift linkage (A) and reinstall pin (C).
The pin may be installed from either side of the boot.
3. Secure pin (C) with hairpin (D).
4. Repeat Step
1, page 215
boot on the opposite side of the windrower.
215676
to Step
3, page 215
to install the
OPERATION
Figure 4.105: Header Float Linkage
Figure 4.106: Header Boot
B
Figure 4.107: Header Boot
215
A
A
A
D
C
B
B
Revision A
Advertisement
Table of Contents
Troubleshooting
