Checking Engine Coolant - MacDon M2170NT Operator's Manual

Table 6.6 Tire Pressure Specifications – M2 Series Windrowers Paired with Auger Headers
Header Type
A40DX
A40DX GSS
A40DX
A40DX

6.7.5 Checking Engine Coolant

Coolant is cycled through the engine to help reduce internal heat. The coolant must be at the appropriate level for the
cooling system to work correctly. Check the coolant level in the pressurized coolant tank daily.
DANGER
To prevent bodily injury or death from the unexpected startup of the machine, always stop the engine and remove the
key from the ignition before leaving the operator's seat for any reason.
NOTE:
Ensure the engine has cooled down prior to checking.
1. Shut down the engine, and remove the key from the ignition.
2. Open the hood. For instructions, refer to
3. Locate coolant recovery tank (A).
4. Visually inspect the coolant level. Ensure that the coolant
level is at MAX COLD line (B). If the coolant level is too low,
add more coolant. For instructions, refer to
after System Drain, page
6.1.2 Lubricants, Fluids, and System Capacities, page
For coolant specifications, refer to
Specifications, page 281.
5. Close the hood. For instructions, refer to
262171
MAINTENANCE AND SERVICING
Description
4.9 m (16 ft.)
4.9 m (16 ft.)
(Grass Seed)
5.5 m (18 ft.)
5.5 m (18 ft.)
6.3.1 Opening Hood, page
Adding Coolant
368. For fluid quantities, refer to
6.1.4 Coolant
6.3.2 Closing Hood, page
Drive Wheel Tire Type
Bar or Turf
Bar or Turf
Bar
Turf
287.
279.
Figure 6.56: Coolant Recovery Tank
288.
324
Pressure kPa (psi)
200 (29)
159 (23)
200 (29)
220 (32)
A
B
Revision A